Dell 9.7(0.0) PREFIX-LIST Mode, Protocol Gvrp Mode, Rapid Spanning Tree Rstp Mode, ROUTE-MAP Mode

PREFIX-LIST Mode

To configure a prefix list, use PREFIX-LIST mode.

To enter PREFIX-LIST mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the ip prefix-listcommand. Include a name for the prefix list. The prompt changes to include (conf-nprefixl).

You can return to CONFIGURATION mode by using the exit command.

PROTOCOL GVRP Mode

To enable and configure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For more information, refer to GARP VLAN Registration (GVRP).

To enter PROTOCOL GVRP mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the protocol gvrp command. The prompt changes to include (config-gvrp).

You can return to CONFIGURATION mode by using the exit command.

RAPID SPANNING TREE (RSTP) Mode

To enable and configure RSTP, use RSTP mode. For more information, refer to Rapid Spanning Tree Protocol (RSTP).

To enter RSTP mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Enter the protocol spanning-tree rstp command. The prompt changes to include (conf-rstp).

You can return to CONFIGURATION mode by using the exit command.

ROUTE-MAP Mode

To configure a route map, use ROUTE-MAP mode.

To enter ROUTE-MAP mode:

1.Verify that you are logged in to CONFIGURATION mode.

2.Use the route-map map-name[permit deny] [sequence-number] command. The prompt changes to include (config-route-map).

You can return to CONFIGURATION mode by using the exit command.

ROUTER BGP Mode

To enable and configure Border Gateway Protocol (BGP), use ROUTER BGP mode. For more information, refer to Border Gateway Protocol IPv4 (BGPv4)

To enter ROUTER BGP mode:

1.Verify that you are logged in to CONFIGURATION mode.

CLI Basics 55