Dell 9.7(0.0) manual S6000

upgrade system

Upgrade the system image.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

upgrade system {flash: ftp: scp: tftp: usbflash:

stack-unit {0-5 all} {A: B:}

0–5	Enter the keywords 0–5to upgrade only the mentioned
	stack-unit.
all	Enter the keyword all to upgrade all the member units of
	the stack.
ftp	Enter the keyword ftp to follow it with the location of the
	source file in this form: //userid:password@hostip/filepath,
	or press Enter to launch a prompt sequence.
scp	Enter the keyword scp to follow it with the location of the
	source file in this form: //userid:password@hostip/filepath,
	or press Enter to launch a prompt sequence.
tftp	Enter the keyword tftp to follow it with the location of the
	source file in this form: //hostlocation/filepath, or press
	Enter to launch a prompt sequence.
flash	Enter the keyword flash to follow it with the location of the
	source file in this form: //filepath, or press Enter to launch a
	prompt sequence.
usbflash	Enter the keyword flash to follow it with the location of the
	source file in this form: //filepath, or press Enter to launch a
	prompt sequence.
A	Enter the keywordA to upgrade the bootflash partition A
B	Enter the keyword B to upgrade the bootflash partition B.
none
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0	Introduced on the S6000.
Version	Added support for IPv6 for the file-urlparameter.
9.0(0.0)

File Management 85