Dell 9.7(0.0) manual Protocol-tunnel destination-mac, Rate-limit rate, Stp

Parameters

Defaults

Command Modes

Command History

Example

Related Command

To disable protocol tunneling for a Layer 2 protocol, use the no protocol- tunnel command.

rate-limit rate	Enter the keyword rate-limitfollowed by a number for
	the rate-limit for tunneled packets on the VMAN. The range
	is from 64 to 320.
stp	Enter the keyword stp to enable protocol tunneling on a
	spanning tree, including STP, MSTP, RSTP, and PVST.
none
CONF-IF-VLAN

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guid.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.11.1Introduced on the Z9000.

8.5.1.1Added support for 802.1X, E-LMI, GMRP, GVRP, LLDP, LACP,

MMRP, MVRP, and OAM 802.3ah protocol traffic to the E- Series ExaScale.

8.2.1.0Introduced on the C-Series, E-Series, and E-Series ExaScale.

7.4.1.0Introduced

Dell#conf

Dell(conf)#interface vlan 2

Dell(conf-if-vl-2)#vlan-stack compatible

Dell(conf-if-vl-2)#member Te 1/2-3

Dell(conf-if-vl-2)#protocol-tunnel stp

Dell(conf-if-vl-2)#protocol-tunnel enable

show protocol-tunnel — displays tunneling information for all VLANs.

protocol-tunnel destination-mac

Overwrite the BPDU destination MAC address with a specific value.

Syntax protocol-tunnel destination-mac xstp address

1458 Service Provider Bridging