Dell 9.7(0.0) manual Neighbor description, Name Text

Route-map configuration on a BGP peer or peer group works only when the LOC- RIB contains at least one route.

When you apply a default route to a BGP peer or peer group using the neighbor default-originatecommand, changes to the configured default route-map are applied to the BGP peer or peer group only after a delay of 15 seconds. As a result, you must wait for a period of 15 seconds before manually resetting BGP using the clear ip bgp command.

In case of eBGP, the neighbor default-originatecommand does not support extended-communityas a non-transtive route-map attribute.

You cannot set this configuration for a peer that is associated with a peer group. Similarly, you cannot associate a peer to a peer group if that peer is already configured with these settings.

In order that settings corresponding to the neighbor default-originatecommand take effect, you must execute the clear ip bgp command immediately after you execute the neighbor default-originatecommand.

neighbor description

Assign a character string describing the neighbor or group of neighbors (peer group).

S6000

Syntaxneighbor {ip-address peer-group-name} description text

Parameters

Defaults

Command Modes

Command History

To delete a description, use the no neighbor {ip-addresspeer-group- name} description command.

ip-address	Enter the IP address of the neighbor in dotted decimal
	format.
peer-group-	Enter the name of the peer group.
name
text	Enter a continuous text string up to 80 characters.
Not configured.
ROUTER BGP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

Border Gateway Protocol 385