Dell 9.7(0.0) manual Mode tx rx, Multiplier integer

mode

To receive or transmit, set LLDP.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

Related Commands

mode {tx rx}

To return to the default, use the no mode {tx rx} command.

tx	Enter the keyword tx to set the mode to transmit.
rx	Enter the keyword rx to set the mode to receive.

Both transmit and receive.

CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

7.4.1.0Introduced on the E-Series.

protocol lldp (Configuration) — enables LLDP globally.

show lldp neighbors — displays the LLDP neighbors.

multiplier

Set the number of consecutive misses before LLDP declares the interface dead.

S6000

Syntax	multiplier integer
	To return to the default, use the no multiplier integer command.

960 Link Layer Discovery Protocol (LLDP)