Dell 9.7(0.0) manual Fcoe priority-bits priority-bitmap, Priority-bitmap

Parameters

Defaults

Command Modes

{all auto- detect-timer config-exchng fail mgmt resource sem tlv}

none

EXEC Privilege

Enter the type of debugging, where:

•all: enables all DCBX debugging operations.

•auto-detect-timer: enables traces for DCBX auto- detect timers.

•config-exchng: enables traces for DCBX configuration exchanges.

•fail: enables traces for DCBX failures.

•mgmt: enables traces for DCBX management frames.

•resource: enables traces for DCBX system resource frames.

•sem: enables traces for the DCBX state machine.

•tlv: enables traces for DCBX TLVs.

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.

fcoe priority-bits

Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.

Syntax	fcoe priority-bits priority-bitmap
	To remove the configured FCoE priority, use the no fcoe priority-bits
	command.
Parameters	priority-bitmap	Enter the priority-bitmap range. The range is from 1 to FF.
Defaults	0x8
Command	PROTOCOL LLDP
Modes

Data Center Bridging (DCB) 495