Related Commands

interface — configures a physical interface on the switch.

show ip interface — displays Layer 3 information about the interfaces.

show interfaces — displays information on a specific physical interface or virtual interface.

show interfaces transceiver — displays the physical status and operational status of an installed transceiver. The output also displays the transceiver’s serial number.

show interfaces transceiver

Display the physical status and operational status of an installed transceiver. The output also displays the transceiver’s serial number.

S6000

Syntax

Parameters

Command Modes

Command History

show interfaces [tengigabitethernet slot/port fortyGigE slot/ port] transceiver

tengigabitether

For a 10-Gigabit Ethernet interface, enter the keyword

net

TenGigabitEthernet then the slot/port information.

fortyGigE

For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on theS6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.1.1.0Introduced on the E-Series ExaScale.

7.8.1.0Output augmented with diagnostic data for pluggable media.

Interfaces

717

Page 717
Image 717
Dell 9.7(0.0) manual Show interfaces transceiver, Tengigabitether, Net, FortyGigE