Command Modes

Command History

Usage Information

NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Added support for VRF. Introduced on the S6000-ON.

9.5(0.0)

Introduced on the Z9500.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.11.1Introduced on the Z9000.

8.1.1.0Introduced on the E-Series ExaScale.

7.8.1.0Introduced on the S-Series.

The following describes the show ip pim interface command shown in the following example.

Field

Description

Address

Lists the IP addresses of the interfaces participating in PIM.

Interface

List the interface type, with either slot/port information or ID

 

(VLAN or Port Channel), of the interfaces participating in

 

PIM.

Ver/Mode

Displays the PIM version number and mode for each

 

interface participating in PIM:

 

• v2 = PIM version 2

 

• S = PIM Sparse mode

Nbr Count

Displays the number of PIM neighbors discovered over this

 

interface.

Query Intvl

Displays the query interval for Router Query messages on

 

that interface (configured with ip pim query-interval

 

command).

DR Prio

Displays the Designated Router priority value configured on

 

the interface (use the ip pim dr-prioritycommand).

PIM-Sparse Mode (PIM-SM)

1205

Page 1205
Image 1205
Dell 9.7(0.0) manual Field Description Address, Ver/Mode, Nbr Count, Query Intvl, DR Prio