VersionDescription

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

neighbor distribute-list

Distribute BGP information via an established prefix list.

S6000

Syntaxneighbor {ip-address peer-group-name} distribute-list prefix- list-name{in out}

Parameters

To delete a neighbor distribution list, use the no neighbor {ip-addresspeer-group-name}distribute-listprefix-list-name{in out} command.

ip-address

Enter the IP address of the neighbor in dotted decimal

 

format.

peer-group- name

prefix-list- name

Enter the name of the peer group to apply the distribute list filter to all routers in the peer group.

Enter the name of an established prefix list.

If the prefix list is not configured, the default is permit (to allow all routes).

Defaults

Command Modes

Command History

in

Enter the keyword in to distribute only inbound traffic.

out

Enter the keyword out to distribute only outbound traffic.

Not configured.

 

ROUTER BGP

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

386

Border Gateway Protocol

Page 386
Image 386
Dell 9.7(0.0) manual Neighbor distribute-list, Peer-group- name Prefix-list- name