Dell 9.7(0.0) manual Show ipv6 management-route, Command History Example

Command History

Example

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0	Introduced on the E-Series.
Dell#show ip management-route
Destination	Gateway	State
-----------	-------	-----
10.1.2.0/24	ManagementEthernet 0/0	Connected
172.16.1.0/24	10.1.2.4	Active
Dell#

show ipv6 management-route

Display the IPv6 static routes configured for the management interface.

S6000

Syntaxshow ipv6 management-route [all connected summary static]

Parameters	(OPTIONAL) Enter the keyword all to view all IP addresses
all
	assigned to all Management interfaces on the switch.
connected	(OPTIONAL) Enter the keyword connected to view only
	routes directly connected to the Management interface.
summary	(OPTIONAL) Enter the keyword summary to view a table
	listing the number of active and non-active routes and their
	sources.
static	(OPTIONAL) Enter the keyword static to view non-active
	routes also.

802 IPv4 Routing