Dell 9.7(0.0) manual Neighbor add-path, Send

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

Usage	By default, when you create a neighbor/peer group configuration in the Router
Information	BGP context, this enables IPv4/Unicast AFI/SAFI. When you use activate in the
	new context, the neighbor/peer group enables for AFI/SAFI.
	It is not possible to de-activate a peer from the IPv4 unicast address family.

neighbor add-path

This command allows the specified neighbor/peer group to send/receive multiple path advertisements.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

neighbor [ip-address peer-group-name] add-path [send receive both] path-count

ip-address	(OPTIONAL) Enter the IP address of the neighbor in dotted
	decimal format.
peer-group-	(OPTIONAL) Enter the name of the peer group.
name
send	Enter the keyword send to indicate that the system sends
	multiple paths to peers.
receive	Enter the keyword receive to indicate that the system
	accepts multiple paths from peers.
both	Enter the keyword both to indicate that the system sends
	and accepts multiple paths from peers.
path-count	Enter the number paths supported. The range is from 2 to
	64.

none

CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

380 Border Gateway Protocol