Dell 9.7(0.0) manual Permit icmp, Example Manual Profiles Related Commands, Parameters Defaults

Example (Manual Profiles)

Related Commands

Dell#show		cam-acl
-- Chassis Cam ACL --
L2Acl	Current Settings(in block sizes)
	:	2
Ipv4Acl	:	2
Ipv6Acl	:	4
Ipv4Qos	:	2
L2Qos	:	3
-- Line	card 4 --
L2Acl	:	Current Settings(in block sizes)
		2
Ipv4Acl	:	2
Ipv6Acl	:	4
Ipv4Qos	:	2
L2Qos	:	3
Dell#show		cam-acl

cam-acl — configures CAM profiles to support IPv6 ACLs.

permit icmp

To allow all or specific internet control message protocol (ICMP) messages, configure a filter.

S6000

Syntaxpermit icmp {source address mask any host ipv6-address} {destination address any host ipv6-address} [count [byte]]

To remove this filter, you have two choices:

•Use the no seq sequence-numbercommand if you know the filter’s sequence number.

•Use the no permit icmp {source address mask any host ipv6- address} {destination address any host ipv6-address} command.

Parameters
Defaults	Not configured.
Command	ACCESS-LIST
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

IPv6 Access Control Lists (IPv6 ACLs) 833