Dell 9.7(0.0) manual Ip tftp vrf vrf-name, Specify the VRF that is used by the Tftp client

Defaults

Command Modes

Command History

•For a port channel interface, enter the keywords port- channel then a number. The range is from 1 to 128.

•For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

•For a tunnel interface, enter the keyword tunnel.

The IP address on the system that is closest to the Telnet address is used in the outgoing packets.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0	Introduced on the S6000.
Version	Introduced on the S4820T.
8.3.19.0
Version 8.3.11.1	Introduced on the Z9000.
Version 8.3.7.0	Introduced on the S4810.
Version 8.5.1.0	Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0	Increased number of VLANs on ExaScale to 4094 (was 2094).
Version 8.1.1.0	Introduced on the E-Series ExaScale.
Version 7.6.1.0	Introduced on the S-Series.
Version 7.5.1.0	Introduced on the C-Series.
E-Series	Original command.

ip tftp vrf

Configures an TFTP client with a VRF that is used to connect to the TFTP server.

Syntax	ip tftp [vrf vrf-name]
	To undo the TFTP client configuration, use the no ip tftp [vrf vrf-name]
	command.

Parameters	Enter the keyword vrf and then the name of the VRF to
vrf vrf-name
	specify the VRF that is used by the TFTP client.

Control and Monitoring 109