Defaults

Command Modes

Command History

validate-reply

(IPv4 only) Enter Y or N for reply validation.

 

• N: Do not validate reply data.

 

• Y: Do validate reply data.

 

Default is No.

outgoing-

(IPv6 link-local address) Enter the outgoing interface for ping

interface

packets to a destination link-local address.

pattern pattern

(IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF.

 

Default: 0xABCD.

sweep-min-

Enter the minimum size of datagram in sweep range. The

size

range is from 52 to 15359 bytes.

sweep-max-

Enter the maximum size of datagram in sweep range. The

size

range is from 53 to 15359 bytes.

sweep-interval

Enter the incremental value for sweep size. The range is from

 

1 to 15308 seconds.

interface

(IPv4 only) Enter the outgoing interface for multicast packets.

 

Enter the IP address in A.B.C.D format.

 

• For a 10-Gigabit Ethernet interface, enter the keyword

 

TenGigabitEthernet then the slot/port information.

 

• For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

 

• For a port channel interface, enter the keywords port-

 

channel then a number. The range is from 1 to 128.

 

• For a VLAN interface, enter the keyword vlan then a

 

number from 1 to 4094.

none

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Introduced on the S6000.

Version 9.0.0.0

Introduced on the Z9000.

Version

Introduced on the S4820T.

8.3.19.0

 

 

Added support for the outgoing-interfaceoption for

 

link-local IPv6 addressing on the S4820T.

Control and Monitoring

119

Page 119
Image 119
Dell 9.7(0.0) manual Validate-reply, Outgoing, Sweep-min, Size, Sweep-max, Sweep-interval