Dell 9.7(0.0) manual Interface port-channel channel-number, Channel

interface port-channel

Create a Port Channel interface, which is a link aggregation group (LAG) containing 16 physical interfaces on the S-Series.

S6000

Syntax interface port-channel channel-number

Parameters

Defaults

Command Modes

Command History

Usage Information

To delete a Port Channel, use the no interface port-channelchannel- number command.

channel-	For a Port Channel interface, enter the keywords port-
number	channel then a number. The range is from 1 to 128.
Not configured.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
Version 9.0.2.0	Introduced on the S6000.
Version 8.3.19.0	Introduced on the S4820T.
Version 8.3.12.0	Introduced on S4810.
Version 8.3.11.1	Introduced on Z9000.
Version 8.1.1.0	Introduced on E-Series ExaScale.
Version 7.6.1.0	Introduced on S-Series.
Version 7.5.1.0	Introduced on C-Series.
pre-Version	Introduced on E-Series.
6.2.1.0

Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by using the switchport command) or Layer 3 mode (by configuring an IP address). You can add a Port Channel in Layer 2 mode to a VLAN.

The shutdown, description, and name commands are the only commands that you can configure on an interface while it is a member of a Port Channel. To add a physical interface to a Port Channel, the interface can only have the shutdown, description, and name commands configured. The Port Channel’s configuration is applied to the interfaces within the Port Channel.

732 Interfaces