Dell 9.7(0.0) - page 431

Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of
the VRF to view route information that matches the filter lists
corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to view information related only to ipv4
multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword unicast to view information related only to ipv4
unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the
keyword unicast to view information related only to ipv6
unicast routes.
as-path-name Enter an AS-PATH access list name. The range is 140
characters.
Command
Modes • EXEC
• EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information The following describes the show ip bgp filter-list hello command
shown in the following example.
Field Description
Path source
codes
Lists the path sources shown to the right of the last AS
number in the Path column:
• i = internal route entry
Border Gateway Protocol 431