cam-acl (Configuration)
Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6
ACLs, Layer 2 and Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address
validation for DHCP, Ethernet Connectivity Fault Management (CFM) ACLs, OpenFlow, and Policy-based
Routing (PBR).
S6000
Syntax cam-acl {default | l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number l2pt number ipmacacl number [vman-
qos | vman-dual-qos number] ecfmacl number [nlbclusteracl
number] ipv4pbr number }openflow number | fcoe number}
[iscsioptacl number] [vrfv4acl number]
Parameters default Use the default CAM profile settings and set the CAM as
follows:
• L2Acl : 6
• IPV4Acl : 4
• IPV6Acl : 0
• IPV4Qos : 2
• L2Qos : 1
• L2PT : 0
• IpMacAcl : 0
• VmanQos : 0
• VmanDualQos : 0
• EcfmAcl : 0
• nlbclusteracl: 0
• FcoeAcl : 0
• iscsiOptAcl : 0
• ipv4pbr : 0
• vrfv4Acl :0
• Openflow : 0
• fedgovacl : 0
l2acl number Enter the keyword l2acl and then the number of l2acl
blocks. The range is from 1 to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP
blocks for IPv4. The range is from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP
blocks for IPv6. The range is from 0 to 4.
ipv4qos
number
Enter the keyword ipv4qos and then the number of FP
blocks for IPv4. The range is from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks
for l2 qos. The range is from 1to 8.
460 Content Addressable Memory (CAM)