Version Description
8.3.19.0 Introduced on the S4820T.
Usage
Information In general, the path cost is calculated as:
10^8 / bandwidth
Using this formula, the default path cost is calculated as:
• GigabitEthernet—Default cost is 1
• TenGigabitEthernet—Default cost is 1
• FortygigEthernet — Default cost is 1
• Ethernet—Default cost is 10
ipv6 ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the time interval elapses,
the neighboring routers declare the router down.
Syntax ipv6 ospf dead-interval seconds
To return to the default time interval, use the no ipv6 ospf dead-interval
command.
Parameters seconds Enter the time interval in seconds. The range is from 1 to
65535 seconds.
Defaults 40 seconds (Ethernet).
Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.1.(0.0) Introduced on the S4810 and Z9000.
7.8.1.0 Added support for C-Series.
7.4.1.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Open Shortest Path First (OSPFv2 and OSPFv3) 1155