Usage Information

Related Commands

VersionDescription

pre-6.1.1.0

Introduced on the E-Series.

When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol route) is preferred over the Management Static route. Also, Management static routes and the Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4 and IPv6 management routes. This command manages both tables.

interface ManagementEthernet — configures the Management port on the system (either the Primary or Standby RPM).

speed (Management interface) — sets the speed for the Management interface.

show arp

Display the ARP table.

S6000

Syntaxshow arp [vrf vrf-name] [interface interface ip ip-address[mask] macaddress mac-address[mac-address mask]] [retries] [static dynamic] [inspection {database statistics][summary]

Parameters

(OPTIONAL) Enter the keyword vrf and then the name of

vrf vrf-name

 

the VRF.

 

NOTE: Use this attribute to start a BGP instance for either

 

a specific address family corresponding to the default

 

VRF or an IPv4 address family corresponding to a non-

 

default VRF.

interface

(OPTIONAL) Enter the following keywords and slot/port or

interface

number information:

 

• For a 10-Gigabit Ethernet interface, enter the keyword

 

TenGigabitEthernet then the slot/port information.

 

• For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

 

• For the Management interface on the stack-unit, enter

 

the keyword ManagementEthernet then the slot/port

 

information. The slot range is from 0 to 1. The port range

 

is 0.

 

• For a port channel interface, enter the keywords port-

 

channel then a number. The range is from 1 to 128.

 

• For a VLAN interface, enter the keyword vlan then a

 

number from 1 to 4094.

786

IPv4 Routing

Page 786
Image 786
Dell 9.7(0.0) manual Show arp, Parameters