Command History

Related Commands

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0

Introduced on the E-Series.

set level — specify the OSPF area for route redistribution.

set metric — specify the metric value assigned to redistributed routes.

set metric-type — specify the metric type assigned to redistributed routes.

set tag — specify the tag assigned to redistributed routes.

set comm-list delete

To remove the specified community list from the BGP route’s COMMUNITY attribute, configure a filter.

Syntax

set comm-list community-list-namedelete

Parameters

Defaults

Command Modes

Command History

To insert the community list into the COMMUNITY attribute, use the no set comm-listcommunity-list-namedelete command.

community-

Enter the name of an established Community list, up to 140

list-name

characters.

Not configured.

 

ROUTE-MAP

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Access Control Lists (ACL)

259

Page 259
Image 259
Dell 9.7(0.0) manual Set comm-list delete, Set comm-list community-list-name delete