Related Commands

the DOWN timer is running when an interface goes down and comes back up, the DOWN timer is cancelled and the client is not notified of the event.

If the timer expires and an object’s state has changed, a notification is sent to the client. If no delay is configured, a notification is sent immediately after a change in the state of a tracked object is detected. The time delay in communicating a state change is specified in seconds.

•track interface ip routing – configures object tracking on the routing status of an IPv4 Layer 3 interface.

•track interface line-protocol – configures object tracking on the line-protocol state of a Layer 2 interface.

•track ip route metric threshold – configures object tracking on the threshold of an IPv4 route metric.

•track ip route reachability – configures object tracking on the reachability of an IPv4 route.

description

Enter a description of a tracked object.

Syntax

description {text}

 

To remove the description, use the no description {text} command.

Parameters

text

Enter a description to identify a tracked object (80 characters

 

maximum).

Defaults

Command Modes

Command History

Related Commands

none

OBJECT TRACKING (conf_track_object-id)

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

8.3.12.0Introduced on the S4810.

8.4.1.0Introduced.

•track interface ip routing – configures object tracking on the routing status of an IPv4 Layer 3 interface.

•track interface line-protocol – configures object tracking on the line-protocol state of a Layer 2 interface.

•track ip route metric threshold – configures object tracking on the threshold of an IPv4 route metric.

•track ip route reachability – configures object tracking on the reachability of an IPv4 route.

Object Tracking

1041

Page 1041
Image 1041
Dell 9.7(0.0) manual Related Commands, Description text