Dell 9.7(0.0) manual Vlan-stack dot1p-mapping, Vlan-stack protocol-type, Tag-dot1p, Sp-tag-dot1p

M Te 1/18

M Te 1/6

Dell#

vlan-stack dot1p-mapping

Map C-Tag dot1p values to a S-Tag dot1p value. You can separate the C-Tag values by commas and dashed ranges are permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration in case of conflicts.

Syntax

Parameters

Defaults

Command Modes

Command History

vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value

c-tag-dot1p	Enter the keyword c-tag-dot1pthen the customer dot1p
value	value that is mapped to a service provider do1p value. The
	range is from 0 to 7.
sp-tag-dot1p	Enter the keyword sp-tag-dot1pthen the service provider
value	dot1p value. The range is from 0 to 7.
none
INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.7.0Introduced on the S4810.

8.3.1.0Introduced on the C-Series and S-Series.

vlan-stack protocol-type

Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN tag). If you do not configure this command, Dell Networking OS assigns the value 0x9100.

Syntax vlan-stack protocol-type number

1602 VLAN Stacking