Slot/port

Limit

MAC count

MAC count

Drops

Te 1/1

10

0

0

0

Virtual LAN (VLAN) Commands

The following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface and use many of the same commands as physical interfaces.

You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP, ACLs and SNMP are not supported on a VLAN.

Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN interface may continually switch between Master and Backup.

NOTE: For more information, refer to VLAN Stacking and VLAN-related commands, such as portmode hybrid in the Interfaces chapter.

default vlan-id

Specify a VLAN as the Default VLAN.

S6000

Syntax

default vlan-id vlan-id

Parameters

Defaults

Command Modes

Command History

To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the no default vlan-idvlan-idsyntax.

vlan-id

Enter the VLAN ID number of the VLAN to become the new

 

Default VLAN. The range is from 1 to 4094. The default is 1.

The Default VLAN is VLAN 1.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

932

Layer 2

Page 932
Image 932
Dell 9.7(0.0) manual Virtual LAN Vlan Commands, Slot/port Limit MAC count Drops Te 1/1, Default vlan-id vlan-id