Defaults

Command

Modes

Command

History

Usage

Information

Example (Single Range)

Related

Commands

NOTE: Associate the OpenFlow instance with the VLAN when the VLAN is created. An existing VLAN cannot be associated with an OpenFlow instance.

Not configured, except for the Default VLAN, which is configured as VLAN 1.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.0.2.0Introduced on the S6000.

9.1.(0.0)

Introduced on the S4810; added support for OpenFlow.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

For more information about VLANs and the commands to configure them, refer to the Virtual LAN (VLAN) Commands section of the Layer 2 chapter.

FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP ACLs are supported. For more information, refer to the Access Control Lists (ACL) chapter.

The following features are not supported on VLANs associated with an OpenFlow instance:

•IPv4

•IPv6

•MTU

If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot be enabled simultaneously.

Dell(conf)#int vlan 3

Dell(conf-if-vl-3)#

interface — configures a physical interface.

interface loopback — configures a loopback interface.

interface null — configures a null interface.

interface port-channel — configures a port channel group.

show vlan — displays the current VLAN configuration on the switch.

686

Interfaces

Page 686
Image 686
Dell 9.7(0.0) manual Introduced on the S4810 added support for OpenFlow, Dellconf#int vlan Dellconf-if-vl-3#