Dell 9.7(0.0) manual Sflow collector, Format for IPv4 or xxxxx format for IPv6, Fields of zeros

sflow collector

Configure a collector device to which sFlow datagrams are forwarded.

Syntaxsflow collector {ip-address ipv6-address} agent-addr {ip- address ipv6-address} [number [max-datagram-size number]] [max-datagram-size number] [vrf management]

To delete a configured collector, use the no sflow collector {ip-addressipv6-address}agent-addr{ipv4-addressipv6-address} [number [max-datagram-sizenumber]] [max-datagram-sizenumber] [vrf management] command.

Parameters

sflow collector	Enter the IP address of the collector in dotted decimal
ip-address	format for IPv4 or x:x:x:x::x format for IPv6.
ipv6-address	NOTE: The :: notation specifies successive hexadecimal
	fields of zeros.

Defaults

Command Modes

agent-addr ip- address ipv6- address

number

max- datagram-size number

vrf management

Not configured.

CONFIGURATION

Enter the keyword agent-addrfollowed by the sFlow agent IP address in dotted decimal format for IPv4 or x:x:x:x::x format for IPv6.

NOTE: The :: notation specifies successive hexadecimal fields of zeros.

(OPTIONAL) Enter the user datagram protocol (UDP) port number. The range is from 0 to 65535. The default is 6343.

(OPTIONAL) Enter the keyword max-datagram-size then the size number in bytes. The range is from 400 to 1500. The default is 1400.

(OPTIONAL) Enter the keyword vrf followed by the keyword management to configure the collector device corresponding to the default VRF and the management VRF respectively.

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.4.(0.0)	Added support for VRF.

1464 sFlow