Dell 9.7(0.0) manual Cam-optimization qos, Qos Optimize CAM usage for QoS

VersionDescription

8.3.7.0Introduced on the S4810.

cam-optimization

Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

cam-optimization [qos]

qos Optimize CAM usage for QoS.

Disabled.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.2.1.0Introduced on the S-Series.

7.8.1.0Introduced on the C-Series.

Usage	When you enable this command, if a Policy Map containing classification rules (ACL
Information	and/or dscp/ ip-precedence rules) is applied to more than one physical interface
	on the same port pipe, only a single copy of the policy is written (only one FP entry
	is used).
	NOTE: An ACL itself may still require more that a single FP entry, regardless of
	the number of interfaces. For more information, refer to the “IP Access
	Control Lists”, “Prefix Lists”, and “Route-map” sections in the Dell Networking
	OS Configuration Guide.

464 Content Addressable Memory (CAM)