Dell 9.7(0.0) manual Tc-flush-standard, Syntaxtc-flush-standard, DefaultsDisabled

Defaults

Command Modes

Command History

•Port Channel interface with one 10 Gigabit Ethernet = 2000

•Port Channel with two 1 Gigabit Ethernet = 18000

•Port Channel with two 10 Gigabit Ethernet = 1800

•Port Channel with two 100 Mbps Ethernet = 180000

priority priority Enter keyword priority then a value in increments of 16 as the priority. The range is from 0 to 240. The default is 128.

•cost = depends on the interface type

•priority = 128

INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.5.1.0Introduced on the E-Series.

tc-flush-standard

Enable the MAC address flushing after receiving every topology change notification.

S6000

Syntaxtc-flush-standard

To disable, use the no tc-flush-standardcommand.

DefaultsDisabled.

1010 Multiple Spanning Tree Protocol (MSTP)