Parameters

Defaults

Command Modes

Command History

Usage Information

To return to the default values, use the no default-information originate command.

always

(OPTIONAL) Enter the keyword always to enable the switch

 

software to always advertise the default route.

metric metric-

(OPTIONAL) Enter the keyword metric then a number as

value

the metric value. The range is from 1 to 16. The default is 1.

route-map

(OPTIONAL) Enter the keywords route-mapthen the name

map-name

of a configured route-map.

Disabled. Metric: 1.

 

ROUTER RIP

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

pre- 6.2.1.1

Introduced on the E-Series.

The default route must be present in the switch routing table for the default- information originate command to take effect.

default-metric

Change the default metric for routes. To ensure that all redistributed routes use the same metric value, use this command with the redistribute command.

S6000

Syntax

default-metric number

1304

Routing Information Protocol (RIP)

Page 1304
Image 1304
Dell 9.7(0.0) manual Default-metric, Always