fefd-global interval

Configure an interval between FEFD control packets.

Syntax

Parameters

Defaults

Command Modes

Command History

Related Commands

fefd-global interval seconds

To return to the default value, use the no fefd-global interval command.

seconds

Enter a number as the time between FEFD control packets.

 

The range is from 3 to 300 seconds. The default is 15

 

seconds.

15 seconds

 

CONFIGURATION

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

Legacy E-Series command.

fefd — enables far-end failure detection.

fefd-global — enables FEFD globally on the system.

fefd-global

Enable FEFD globally on the system.

S6000

Syntaxfefd-global [interval seconds][mode {normal aggressive}]

To disable FEFD globally, use the no fefd-global [mode {normal aggressive}] command.

Layer 2

949

Page 949
Image 949
Dell 9.7(0.0) manual Fefd-global interval seconds, Syntaxfefd-global interval secondsmode normal aggressive