Dell 9.7(0.0) manual Debug ip igmp, Group-address, Series legacy command

Command Modes

Command History

group-address	(OPTIONAL) Enter the IP multicast group address in dotted
	decimal format.
interface	Enter the following keywords and slot/port or number
interface	information:
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.
	• For a port channel interface, enter the keywords port-
	channel then a number.
	• For a VLAN interface, enter the keyword vlan then a
	number from 1 to 4094.
EXEC

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Added support for VRF. Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

E-Series legacy command

debug ip igmp

Enable debugging of IGMP packets.

S6000

Syntaxdebug ip igmp [vrf vrf-name] [group address interface]

•To disable IGMP debugging, use the no debug ip igmp [vrf vrf-name] [group address interface] command.

•To disable all debugging, use the undebug all command.

Internet Group Management Protocol (IGMP) 639