Dell 9.7(0.0) manual Output-delay delay

Command History

Usage Information

Related Commands

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

When the offset metric is applied to an interface, that value takes precedence over an offset value that is not extended to an interface.

ip prefix-list — enters PREFIX-LIST mode and configure a prefix list.

output-delay

Set the interpacket delay of successive packets to the same neighbor.

S6000

Syntax output-delay delay

Parameters

Defaults

Command Modes

Command History

To return to the switch software defaults for interpacket delay, use the no output-delaycommand.

delay	Specify a number of milliseconds as the delay interval. The
	range is from 8 to 50.
Not configured.
ROUTER RIP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Routing Information Protocol (RIP) 1317