Dell 9.7(0.0) manual Set next-hop ip-address

set metric — specifies the metric value assigned to redistributed routes. set tag — specifies the tag assigned to redistributed routes.

set next-hop

To specify an IP address as the next hop, configure a filter.

Syntax

Parameters

Defaults

Command Modes

Command History

set next-hop ip-address

To delete the setting, use the no set next-hopip-addresscommand.

ip-address Specify an IP address in dotted decimal format.

Not configured.

ROUTE-MAP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0 Introduced on the E-Series.

Usage Information

Related Commands

If you configure the set next-hopcommand, its configuration takes precedence over the neighbor next-hop-selfcommand in the ROUTER BGP mode.

If you configure the set next-hopcommand with the interface’s IP address (either Loopback or physical), the software declares the route unreachable.

match ip next-hop — redistributes routes that match the next-hop IP address.

266 Access Control Lists (ACL)