Dell 9.7(0.0) manual Forwarding, Router-address, Managementet, Hernet, Vlan

Parameters

Defaults

Command Modes

Command History

managementethernet fortyGigE vlan gigabitethernet tengigabitethernet} command.

ip-address	Enter an IP address (dotted decimal format) and mask (/prefix
mask	format) of the destination subnet.
ipv6-address	Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
prefix-length	format) of the destination subnet. Enter the IPv6 address in
	the x:x:x:x::x format followed by the prefix length in the /x
	format.
	The range is from /0 to /128.
	NOTE: The :: notation specifies successive hexadecimal
	fields of zeros.
forwarding-	Enter an IP address (dotted decimal format) or an IPv6
router-address	address (x:x:x:x::x format) of a forwarding router.
managementet	Enter the keyword managementethernet for the
hernet	Management interface on the Primary RPM.
fortyGigE	Enter the keyword fortyGigE to specify a forty Gigbit
	Ethernet interface.
vlan	Enter the keyword vlan to specify a vlan interface.
tengigabitether	Enter the keyword tengigabitethernet to specify a ten Gigabit
net	Ethernete interface.
Not configured.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Added support for forty gigabit, vlan, and tengigabit ethernet
	interfaces. Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.0.0.0Introduced on the Z9000 and added support for IPv6.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.5.1.0Introduced on the C-Series.

IPv4 Routing 785