VOLUME
Press VOLUME A or V. The volume level is displayed as a number from O to MAX (25).
●The volume level is automatically set to 14 if the power is turned off when the volume level is set to 15 or more.
To display the volume level when a function other than TAPE function is selected
Press VOLUME A or V. The volume level is displayed for 4 seconds.
DISPLAY on the remote control is also available.
3-MODE EQUALIZEI?
Press *
The equalizer mode changes to ROCK, POP, JAZZ or no equalization, cyclically.
ROCK - Emphasizes the high and low range of music. POP - Emphasizes voice and midrange of music. JAZZ - Emphasizes the low range of music.
* or EQ on the remote control
T-BASS system
The
Press
QSOUND system
This system provides a rich, three dimensional sound area for stereo sources.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up. c At higher volumes, turning QSOUND on may cause sound distortion. In this case, turn the volume down.
The unit can be turned off automatically at a specified time.
●While CD function is selected, operate the following procedures in stop mode.
Press REPEAT/FM lVIODE/OSC ~=d while pressing STOP/MEMORY ~.
If STOP/MEMORY is kept pressed, another operation may start.
Within 4 seconds, press [++ or M to specify the time until the power is turned off.
Each time it is pressed, the time changes between 10 and 90 minutes in
Specified time | While the sleep timer works, |
| the dot keeps flashing. |
To check the time remaining until the power is turned off
Repeat step 1 shown above. The remaining time is displayed for 4 seconds.
To cancel the sleep timer
Display the remaining time and press M or *I repeatedly until OFF is displayed.
NOTE
If the unit is turned off during tape playback, + on the deck will not be released. Press WA to release +.
If an erroneous display or malfunction occurs Make sure that none of the deck operation buttons is pressed.
Press 9 while pressing POWER (!) STANDBY.
If the unit cannot be reset in the way above, disconnect the AC cord and remove all the batteries to turn off the display. Leave the unit for a while and turn the power back on.
Maintenance
To clean the cabinet
Use a soft cloth lightly mclistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner.
To clean the heads
When the tape heads are dirty;
-high frequency sound is not emitted
-the sound is not adequi~tely high
-the sound is
-the tape cannot be erased
-the tape cannot be recorded on
After every 10 hours of use, clean the tape heads with a head cleaning cassette.
Use separately sold
Refer to the instructions c)f the cleaning cassette for details.
Lens
To clean the lens
Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge.
ENGLISH ~