Dell 9.7(0.0) manual Stack-unit portmode, Auto

Defaults

Command Modes

Command History

Usage Information

1000	Enter the keyword 1000 to set the interface to auto-
	negotiate its speed.
auto	Enter the keyword auto to set the interface to auto-
	negotiate its speed.
auto
INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.11.1Introduced on the S55, S60, and S4810

8.1.1.0Introduced on the E-Series ExaScale.

7.5.1.0Introduced on the C-Series.

pre-Version	Introduced on the E-Series.
6.2.1.0

This command is found on the Management interface only.

When manually configuring the management port speed the user must consider and match the remote device. It is highly recommended to use Auto-Negotiation for management ports.

Related Commands

interface ManagementEthernet — configures the Management port on the system (either the Primary or Standby RPM).

duplex (10/100 Interfaces) — configures duplex mode on physical interfaces with the speed set to 10/100.

management route — configures a static route that points to the Management interface or a forwarding router.

stack-unit portmode

You can split a single 40G port into four 10G ports without reload.

Interfaces 725