Dell 9.7(0.0) manual Show interfaces configured

Related Commands

Queueing strategy: fifo

Time since last interface status change: 00:05:12

show interfaces configured – displays any interface with a non-default configuration.

show interfaces switchport – displays Layer 2 information about the interfaces.

show inventory (S-Series and Z-Series) – displays the S-Series and Z-Series switch types, components (including media), Dell Networking OS version including hardware identification numbers, and configured protocols.

show range – displays all interfaces configured using the interface range command.

show interfaces configured

Display any interface with a non-default configuration.

S6000

Syntax

Command Modes

Command History

Example

show interfaces configured

•EXEC

•EXEC Privilege

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.4.1.0Changed the organization of the display output.

Dell#show interfaces configured

TenGigabitEthernet 13/18 is up, line protocol is up Hardware is Force10Eth, address is 00:01:e8:05:f7:fc

Current address is 00:01:e8:05:f7:fc Interface index is 474791997 Internet address is 1.1.1.1/24

MTU 1554 bytes, IP MTU 1500 bytes

LineSpeed 1000 Mbit, Mode full duplex, Master

Interfaces 707