Parameters

Command Modes

Command History

vrf vrf-name

Enter the keyword vrf and then the name of the VRF to

 

reset the peer group corresponding to that VRF.

 

NOTE: You can use this attribute on a specific VRF to

 

remove history routes corresponding to that VRF. You

 

can also use this attribute to return the suppressed

 

routes corresponding to a specific VRF to an active state.

peer-group-

Enter the peer group name to reset the BGP sessions within

name

that peer group.

ipv4 multicast

(OPTIONAL) Enter the keyword ipv4 followed by the

 

keyword multicast to reset ipv4 multicast routes.

ipv4 unicast

(OPTIONAL) Enter the keyword ipv4 followed by the

 

keyword unicast to reset ipv4 unicast routes.

ipv6 unicast

(OPTIONAL) Enter the keyword ipv6 followed by the

 

keyword unicast to reset ipv6 unicast routes.

soft

(OPTIONAL) Enter the keyword soft to reset soft

 

configuration.

in

Enter the keyword in to re-configure soft inbound updates.

out

Enter the keyword out to re-configure soft outbound

 

updates.

EXEC Privilege

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Added the ipv4 multicast and ipv6 unicast parameters.

9.4.(0.0)

Added support for VRF.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

Border Gateway Protocol

367

Page 367
Image 367
Dell 9.7(0.0) manual Parameters Command Modes Command History, Peer-group