VersionDescription

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.1.1.0Introduced on the E-Series.

Example

Dell(conf)#interface range tengigabitethernet 1/1 - 2

 

Dell(conf-if-range-gi-1/1-2)#show config

 

!

 

interface TenGigabitEthernet 1/1

 

no ip address

 

switchport

 

no shutdown

 

!

 

interface TenGigabitEthernet 1/2

 

no ip address

 

switchport

 

no shutdown

 

Dell(conf-if-range-gi-1/1-2)#

show interfaces

Display information on a specific physical interface or virtual interface.

S6000

Syntax

show interfaces interface

Parameters

interface

Enter one of the following keywords and slot/port or number

 

information:

• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

• For stack-units, enter the keywords stack-unitthen the slot/port information. The range is from 0 to 11.

• For a Null interface, enter the keyword null then the Null interface number.

• For a port channel interface, enter the keywords port- channel then a number. The range is from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

• For a tunnel interface, enter the keyword tunnel then the tunnel ID. The range is from 1 to 16383.

700

Interfaces

Page 700
Image 700
Dell 9.7(0.0) manual Show interfaces interface