Dell 9.7(0.0) manual End, Seconds

Parameters

Defaults

Command Modes

Command History

Usage Information

interval	Enter the keyword interval then the polling interval in
seconds	seconds. The range is from 120 to 6000 seconds. The
	default is 300 seconds (5 minutes).
Disabled
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.0.2.0Introduced on the S6000.

8.3.19.0Replacement command for the S4820T. Replaces the enable xfp-power-updatescommand.

8.3.11.4Replacement command for the Z9000. Replaces the enable xfp-power-updatescommand

8.3.10.0Replacement command for the S4810 only. Replaces the enable xfp-power-updatescommand.

To enable polling and to configure the polling frequency, use this command.

end

Return to EXEC Privilege mode from other command modes (for example, CONFIGURATION or ROUTER OSPF modes).

Syntax	end
Command	•	CONFIGURATION
Modes
	•	SPANNING TREE
	•	MULTIPLE SPANNING TREE
	•	LINE
	•	INTERFACE
	•	TRACE-LIST
	•	VRRP
	•	ACCESS-LIST
	•	PREFIX-LIST
	• AS-PATH ACL
	•	COMMUNITY-LIST

100 Control and Monitoring