Dell 9.7(0.0) Arp retries number, Enter the number of retries. The range is from 1 to 20

Usage	Use this command to specify the maximum number of ARP entries that the Route
Information	Table Manager can hold for a specific VRF. This command does not apply to the
	management VRFs.

arp retries

Set the number of ARP retries in case the system does not receive an ARP reply in response to an ARP request.

S6000

Syntax	arp retries number
Parameters	number	Enter the number of retries. The range is from 1 to 20. The

default is 5.

Defaults

Command Modes

Command History

Usage Information

Related Commands

5

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.3.1.0Introduced.

Retries are 20 seconds apart.

show arp retries — displays the configured number of ARP retries.

746 IPv4 Routing