Dell 9.7(0.0) manual VRF to enable debugging of Igmp packets corresponding

Parameters

Defaults

Command Modes

Command History

Usage Information

vrf vrf-name	(OPTIONAL) Enter the keyword vrf followed by the name of
	the VRF to enable debugging of IGMP packets corresponding
	to that VRF.
	NOTE: Applies to specific VRF if input is provided, else
	applies to Default VRF.
group-address	(OPTIONAL) Enter the IP multicast group address in dotted
	decimal format.
interface	Enter the following keywords and slot/port or number
interface	information:
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.
	• For a port channel interface, enter the keywords port-
	channel then a number.
Disabled.
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Added support for VRF. Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

E-Series legacy command

IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results. This command displays packets for IGMP and IGMP snooping.

640 Internet Group Management Protocol (IGMP)