Dell 9.7(0.0) manual Interface, Enter one of the following keywords and slot/port or number, Range

Related	show running-config — displays the flow configuration parameters (non-default
Commands	values only).
	show interfaces — displays the negotiated flow control parameters.

interface

Configure a physical interface on the switch.

S6000

Syntax	interface interface range
Parameters	interface	Enter one of the following keywords and slot/port or number

information:

Defaults

Command Modes

Command History

• For a null interface, enter the keyword null then the slot/port information. The Null interface number is 0.

• For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port information. The slot range is from 0 to1. The port range is 0.

• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

	fortyGigE then the slot/port information.
	• For a Tunnel interface, enter the keyword tunnel then
	the tunnel ID. The range is from 1 to 16383.
	• For a VLAN interface, enter the keyword vlan then a
	number from 1 to 4094.
range	(Optional) Enter the keyword range to configure an
	interface range.
Not configured.
CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.4(0.0)	Added the support for interfaces.

674 Interfaces