Dell 9.7(0.0) manual Ipv6-prefix-list, Ipv6-mac, Access-list

Parameters

Defaults

Command

Modes

Command

History

Related Commands

ipv6–access-	Enter the keywords ipv6–access-listthen the access-list
list name	name. The access-list name allows a maximum of 140
	characters.
ipv6–prefix-list	Enter the keywords ipv6–prefix-listthen the prefix-list
name	name. The prefix-list name allows a maximum of 140
	characters.
ipv6–mac-	Enter the keywords ipv6–mac-access-listthen the mac-
access-list	access-list name. The mac-access-list name allows a
name	maximum of 140 characters.

none

POLICY LIST CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.7(0.0)	Introduced on the S4810, S4820T, S5000, S6000, and
	Z9000 switches.

•ipv6 nd ra-guard enable — Allows you to configure the RA guard related commands.

•ipv6 nd raguard policy policy-name — Defines the RA guard policy name and enter the RA guard policy configuration mode.

match ra

Enable verifying either of the configured source IPv6 address or prefix address or the source MAC address in the inspected messages. If this command is not configured, the verification process is bypassed.

Syntaxmatch ra {ipv6-access-list name ipv6-prefix-list name mac- access-list name}

To reset the access list, use the no match ra{ipv6-access-list ipv6- prefix-list mac-access-list}command.

Parameters

ipv6–access-Enter the keywords ipv6–access-listthen the access-list

list name name. The access-list name allows a maximum of 140 characters.

ipv6–prefix-listEnter the keywords ipv6–prefix-listthen the prefix-list

namename. The prefix-list name allows a maximum of 140 characters.

Neighbor Discovery Protocol (NDP) 1029