Defaults

Command Modes

Command History

Usage Information

 

• source-mac— Uses the source MAC address, VLAN,

 

Ethertype, source module ID and source port ID fields to

 

hash. The hashing mechanism returns a 3-bit index

 

indicating which port the packet should be forwarded.

tcp-udp enable

Enter the keywords to distribute traffic based on the

 

following:

 

• enable — Takes the TCP/UDP source and destination

 

ports into consideration when doing hash computations.

 

This option is enabled by default.

ingress-port

Enter the keywords to distribute traffic based on the

enable

following:

 

• enable — Takes the source port into consideration when

 

doing hash computations. This option is disabled by

 

default.

IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.10.0Added the ingress-portparameter for the S4810.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

By default, Dell Networking OS distributes incoming traffic based on a hash algorithm using the following criteria:

•IP source address

•IP destination address

•TCP/UDP source port

•TCP/UDP destination port

782

IPv4 Routing

Page 782
Image 782
Dell 9.7(0.0) manual Tcp-udp enable, Ingress-port, Enable