Parameters

milliseconds

Enter the number of milliseconds as the interval. For IGMP

 

 

 

version 2, the range is from 100 to 25599. For IGMP version

 

 

3, the range is from 100 to 65535. The default value is 1000

 

 

milliseconds.

Defaults

1000 milliseconds

 

Command

INTERFACE

 

Modes

 

 

Command

This guide is platform-specific. For command information about other platforms,

History

refer to the relevant Dell Networking OS Command Line Reference Guide.

 

The following is a list of the Dell Networking OS version history for this command.

 

Version

Description

 

9.7(0.0)

For IGMP version 2, the Interval range is from 100 to 25599.

 

 

Introduced on the S6000-ON.

 

9.2(0.0)

Introduced on the M I/O Aggregator. This command is

 

 

supported in Programmable-Mux (PMUX) mode only.

 

9.0.2.0

Introduced on the S6000.

 

8.3.19.0

Introduced on the S4820T.

 

8.3.11.1

Introduced on the Z9000.

 

8.3.7.0

Introduced on the S4810.

 

7.8.1.0

Introduced on the S-Series.

 

7.7.1.0

Introduced on the C-Series.

 

E-Series legacy

 

 

command

 

ip igmp query-interval

Change the transmission frequency of IGMP general queries the Querier sends.

S6000

Syntax

ip igmp query-interval seconds

 

To return to the default values, use the no ip igmp query-interval

 

command.

 

Parameters

seconds

Enter the number of seconds between queries sent out. The

 

 

 

range is from 1 to 18000. The default is 60 seconds.

Defaults

60 seconds

 

Internet Group Management Protocol (IGMP)

643

Page 643
Image 643
Dell 9.7(0.0) manual 20.0, Ip igmp query-interval seconds