Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.5(0.0)

Introduced on the Z9500.

9.2(0.0)

Introduced on the M I/O Aggregator. This command is

 

supported in Programmable-Mux (PMUX) mode only.

9.0.2.0Introduced on the S6000.

9.0.0.0Introduced on the Z9000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Added support for the peer-down-vlan parameter.

8.3.8.0Introduced on the S4810.

Usage

To configure the VLAN from where the VLT peer forwards packets received over

Information

the VLTi from an adjacent VLT peer that is down, use the peer-down-vlan

 

parameter. When a VLT peer with bare metal provisioning (BMP) is booting up, it

 

sends untagged DHCP discover packets to its peer over the VLTi. To ensure that

 

the DHCP discover packets are forwarded to the VLAN that has the DHCP server,

 

use this configuration.

peer-routing

Enable L3 VLT peer-routing. This command is applicable for both IPV6/ IPV4.

Syntax

peer-routing

 

 

To disable L3 VLT peer-routing, use the no peer-routingcommand.

Defaults

Disabled.

 

Command

VLT DOMAIN (conf-vlt-domain)

Modes

 

 

Command

This guide is platform-specific. For command information about other platforms,

History

refer to the relevant Dell Networking OS Command Line Reference Guide.

 

The following is a list of the Dell Networking OS version history for this command.

 

Version

Description

 

9.7(0.0)

Introduced on the S6000-ON.

 

9.5(0.0)

Introduced on the Z9500.

 

9.4(0.0)

Added the support for IPV6 / IPV4.

 

9.2(0.0)

Introduced on the M I/O Aggregator. This command is

 

 

supported in Programmable-Mux (PMUX) mode only.

1632

Virtual Link Trunking (VLT)

Page 1632
Image 1632
Dell 9.7(0.0) manual Peer-routing