Dell 9.7(0.0) manual Bgp router-id ip-address

bgp router-id

Assign a user-given ID to a BGP router.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

Usage Information

bgp router-id ip-address

To delete a user-assigned IP address, use the no bgp router-idcommand.

ip-address	Enter an IP address in dotted decimal format to reset only
	that BGP neighbor.

The router ID is the highest IP address of the Loopback interface or, if no Loopback interfaces are configured, the highest IP address of a physical interface on the router.

ROUTER BGP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

Peering sessions are reset when you change the router ID of a BGP router.

This command automatically restarts the BGP instance for the configuration to take effect.

Border Gateway Protocol 361