Dell 9.7(0.0) manual Fefd mode normal aggressive, Aggressive

Related Commands

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

Legacy E-Series command.

•fefd — enables far-end failure detection.

fefd mode

Change the FEFD mode on an interface.

Syntax fefd mode {normal aggressive}]

Parameters

Defaults

Command Modes

Command History

To return the FEFD mode to the default of normal, use the no fefd mode command.

normal	(OPTIONAL) Enter the keyword normal to change the link
	state to “unknown” when a far-end failure the software
	detects on that interface. When the interface is placed in
	“unknown” state, the software brings down the line protocol.
aggressive	(OPTIONAL) Enter the keyword aggressive to change the
	link state to “error-disabled” when a far-end failure the
	software detects on that interface. When an interface is
	placed in “error-disabled” state, enter the fefd reset
	command to reset the interface state.
normal
INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

Layer 2 947