Dell 9.7(0.0) manual Command History Usage Information, 20.2 0.0

Added support for the fcoe parameter on the S4810 and S4820T.

Added support for OpenFlow on the Z9000.

Command Modes

cam-acl {default l2acl number ipv4acl number ipv6acl number, ipv4qos number l2qos numberl2ptnu mber ipmacacl number ecfmacl number [vman- qos vman- dual-qos number}

CONFIGURATION

Allocate space to each CAM region.

Enter the CAM profile name then the amount of CAM space to be allotted. The total space allocated must equal 13. The ipv6acl range must be a factor of 2.

Enter 4 or 8 for the number of OpenFlow FP blocks.

•4: Creates 242 entries for use by the OpenFlow controller (256 total entries minus the 14 entries reserved for internal functionality)

•8: Creates 498 entries for use by the OpenFlow controller (512 total entries minus the 14 entries reserved for internal functionality)

Enter the CAM profile name followed by the amount to be allotted. The total space allocated must equal 13. The ipv6acl range must be a factor of 2.

Command History

Usage Information

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.2(0.2)

9.1.(0.0)

8.3.19.0Introduced on the S4820T.

8.3.12.0Added the keywords fcoeacl and iscsioptacl on the S4810.

8.3.11.1Introduced on the Z9000.

8.3.1.0Added the keywords ecfmacl, vman-qos, and vman- dual-qos.

8.2.1.0Introduced on the S-Series.

7.8.1.0Introduced on the C-Series.

For the new settings to take effect, save the new CAM settings to the startup- config (write-memor copy run start) then reload the system.

94 Control and Monitoring