Dell 9.7(0.0) manual Cam-acl-egress, VersionDescription Usage Information

VersionDescription

Usage Information

8.2.1.0Introduced on the S-Series.

7.8.1.0Introduced on the C-Series.

Save the new CAM settings to the startup-config (write-memor copy run start) then reload the system for the new settings to take effect.

The total amount of space allowed is 16 FP Blocks. System flow requires three blocks; these blocks cannot be reallocated. Only 13 number of blocks can be configured by the user .

The ipv6acl allocation must be a factor of 2.

If allocation values are not entered for the CAM regions, the value is 0.

If you enable BMP, to perform a reload on the chassis to upgrade any configuration changes that have changed the NVRAM content, use the command reload conditional nvram-cfg-change.

cam-acl-egress

Allocate CAM for egress ACLs.

S6000

Syntax

Parameters

Command Modes

Command History

cam-acl-egressdefault l2acl number ipv4acl number ipv6acl number

default Reset egress CAM ACL entries to default settings.

l2acl number Allocate space to each CAM region. The total space allocated must equal 4. The ipv6acl range must be a factor of 2.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command..

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

Content Addressable Memory (CAM) 463